Image Lab
Image Lab

Image Lab

Image processing DSK based on TI TMS320C6678 processor

Realtime image processing with a powerful 8-core processor

1 Years warranty

Book Now

Description

The ImagePro 6678 is designed for image processing applications. The ImagePro 6678 uses TMS320C6678, which is one of the most powerful TI multi-core digital signal processors. This board has input and output ports for analog and digital image signals, and a Spartan 6 FPGA with DDR3 and FMC connection.

Introduction

 

The ImagePro 6678 is designed for image processing applications. The ImagePro 6678 uses TMS320C6678, which is one of the most powerful TI multi-core digital signal processors. This board has input and output ports for analog and digital image signals and can do real-time image processing with a powerful 8-core DSP. The DSP can also do 320 Giga Fixed-point multiplications or 160 Giga floating-point multiplications per second. To capture images, the board uses the Spartan 6 FPGA from Xilinx. Its FMC connector can be connected to many different LPC-FMC boards. Also, the board supports USB2 connections for Spartan 6 FPGA and 1G Ethernet for DSP.

Technical Specifications

Image signal
•    NTSC and PAL analog input image with YPbPr, RGB, and Composite format using TVP5146 chip
•    Digital HDMI input port based on TFP401 chip
•    NTSC or PAL analog output image
•    DVI or VGA digital output image based on CH7301C chip


DSP

•    8-core Digital Signal Processor (DSP) TMS320C6678CYP
•    320GMAC fixed-point and 160GFLOP floating-point processing power
•    1GHz and 1.25GHz DSP clock
•    1GB DDR3 memory with the speed of 1333MBPS
•    10/100/1000 Ethernet
•    128 MB  NAND Flash
•    16MB NOR Flash
•    128KB EEPROM
•    4 boot modes (selectable with DIP-switch)
•    RS232 port
•    EMIF connection between DSP and FPGA
•    Can be programmed with Code Composer Studio
•    14-pin JTAG connector for low-cost JTAGs
•    Full 60-PIN JTAG connector for XDS560 

 

FPGA

•    Spartan 6 FPGA XC6SLX45T-3FGG484
•    128MB DDR3 memory with 800Mbit per second transfer rate
•    8MB SPI Flash for bootload
•    USB2 hardware
•    LPC-FMC VITA 57.1 with 68 GPIO
•    2 push buttons
•    2 serial ports
•    2 LEDs
•    I2C interface for image chip programming 
•    Rx and Tx image chip connection to FPGA only
•    30MHz crystal oscillator

See More

Document

We plan to make this hardware available for students without any prior knowledge of DSP programming. We are working hard to make proper documentation for this complicated hardware. The hardware is tested and fully functional with the sample codes and examples. We will update this page as soon as the documentation is ready. 

 

What you’ll receive

•    ImagePro 6678 board with heatsink and fan
•    12V adaptor
•    Documentation
•    XDS100 JTAG with USB cable for PC connection
•    Color LCD with 12V adaptor
•    Analog camera with cable
•    MINI USB cable for FPGA connection
•    Ethernet cable
•    HDMI cable for digital image input
•    Composite output cable  
•    DB15 to composite cable

 

Gallery

Buy Now Book Now